• Mask the face of the bumper as shown in photos starting at the
fog lights, line up the tape with the edge of the opening holding a
straight line around the corner and a 1/4” above the point on the
bumper at the fender well –Photos X & Y
• Cut off the bottom of the bumper at your masking line.
• Reinstall top half of bumper, this is what you should end up
with. Flares should be about 1/4” higher than bumper. –Photos
AA, BB, CC
T 3 F R O N T B U M P E R I N S T A L L A T I O N I N S T R U C T I O N S
page 5-5
AA
X
Y
BB
CC
• Fog light bracket
Mount the fog light bracket to factory fog lights using the 1/4”
hardware provided.
• Install bumper
NOTE:
If installing a winch, mount winch to bumper prier to
installation.
Using the factory bumper hardware and strut washers, secure the
bumper to the front frame plates.
**
CAUTION
make sure bumper is centered and frame brackets are
installed before tightening bolts.
• Frame bracket install
Remove bolts from sway bar and install frame bracket under the
sway bar bracket. Use the 1/2” hardware in the remaining frame
plate holes.
