VRC2100 Vending Reader
20
Installation Guide
5.
Enter configuration changes and then click
SUBMIT CHANGES
to
send the new values to the reader. The reader will save the changes
in flash memory and will reset itself to start using the new
configuration.
6.
To review the current settings after the reader has completed a
reboot, click
CONNECT
again to start the process over.
4.3 Slave Operation
For Slave operation, CBORD recommends that the configuration
initially be set using the buttons described in section 3.6 (
Controller
Configuration
). Once connected and operating in a daisy-chain, the Slave
reader configuration can be updated using the
Flash Updater and
Configurator
program described in section 4.2 (
Remotely Read and
Change VRC2100 Configuration
).
Note that if you select the
Slave
check box in the
Master/Slave
area on
the
VRC2100 Configuration
tab to change a reader from Master mode to
Slave mode, the reader will no longer be responsive after the configuration
changes have been sent. The reader will need to be wired to a Master as
illustrated below in order to be accessible by the
Flash Updater and
Configurator
program. The same applies if you change a reader from
Slave mode to Master mode.
