Implement settings
91
GPS source
1. Press the button "GPS source".
The "GPS source" selection list is displayed.
2. Select the GPS source.
3. If you have selected "RS232 - serial", then define the serial in-
terface and baud rate now.
4. End the Process with "Back".
The "GPS settings" operating screen is displayed.
GPS source
Dependent on the model, a GPS receiver sends position data
in the NMEA 0183 protocol via the serial interface or
in the NMEA 2000 protocol via the CAN-Bus.
The terminal supports both protocols.
Connect GPS receiver and terminal as follows:
1. The GPS receiver has a serial interface.
Connect the GPS receiver to connector B or C of the terminal.
Select "RS232 - serial" as the GPS source.
Select the connector as the serial interface to which the GPS receiver is
connected.
2. The automatic steering system has a serial interface for the GPS signal.
Connect the serial interface of the steering system to connector B or C
of the terminal.
Select "RS232 - serial" as the GPS source.
Select the connector to which the steering system is connected, as the
serial interface.
3. The GPS receiver has a CAN-Bus interface.
Connect the GPS receiver to the ISOBUS.
Select "ISOBUS" as the GPS source.
GPS simulation
This function is password-protected and provided solely for test
and demonstration purposes.
Using the terminal, you can
record and export a GPS track or
import and play back a GPS track.
Summary of Contents for CCI 1200
