Implement settings
94
6.5
CCI.Convert
When working with an N-sensor and an ISOBUS fertilizer, the application
quantity should be automatically matched to the circumstances on the
field. To do so, the sensor signal must be "translated" so that it is "un-
derstood" by the fertilizer as a setpoint.
CCI.Convert is this translator and converts the manufacturer-specific
signals from N-sensors to implement-readable ISOBUS messages.
The following formats are supported:
LH5000,
ASD and
TUVR.
You know which protocol the sensor uses for data transmission.
You have connected the sensor to the terminal.
In the ISOBUS settings
o
the ISOBUS Task Controller function is "on" and
o
a Task Controller Number is set.
The implement is connected to the ISOBUS.
The implement has a TC client and this is connected to the terminal.
1. Press the "Settings" button on the start screen.
The "Settings" operating screen is displayed.
2. Press the "Apps" button.
The "Apps" operating screen is displayed.
3. Press the "CCI.Config" button.
The "CCI.Config" operating screen is displayed.
4. Press the "CCI.Convert" button.
The "CCI.Convert" operating screen is displayed.
5. Switch CCI.Convert "on".
Prior prepara-
tion
Setting up for
operation
Summary of Contents for CCI 1200
