Data management
112
Setpoint table
The setpoint table of a shape application map contains
one or more columns and
the rows with the setpoints.
When creating the shape application map, give the columns meaningful names.
We recommend the use of product and unit, e.g. "Compost (t)".
Unit selection when importing
It is not apparent from a shape application map which units are to be used, i.e.
whether the product application quantity should be measured in l/ha or kg/m
2
.
The units are specified in two steps when importing the shape application map.
First make a pre-selection and then select the units to be used:
Volume/area
o
l/ha
o
mm
3
/m
2
Mass/area
o
kg/ha
o
t/ha
o
g/m
2
o
mg/m
2
Number/area
o
1/m
2
o
1/ha
Distance
o
mm
o
cm
o
dm
o
m
Percent
o
%
o
‰
o
ppm
Therefore if you want to apply the product in t/ha, select
in step 9 the following direction mass/area and
then in step 11 t/ha.
Summary of Contents for CCI 1200
