Implement settings
71
Mounting type and distance C
1. Check which mounting type the tractor has.
2. Measure distance C for each mounting type.
3. Press the button "Mounting type and distance C".
A selection list is displayed.
4. Sequentially press the buttons of the mounting types and enter
the measured distance C for this mounting type.
5. Press "Back" to end the process after entry of all values.
Mounting type
Normally a tractor has several mountings on the rear.
Distances C
The distance from the tractor reference point to the coupling point is different
for each mounting type:
The distance is measured in the direction of travel.
The tractor reference point is the midpoint of the rear axis.
In CCI.Config, enter the distance C for each mounting type.
It is best to take the trouble to do this immediately during set-up and in this
way avoid renewed measurement when coupling up the implement.
After coupling up an implement, all that is still necessary is to select the
mounting type:
Then Section Control automatically uses the correct distances.
Summary of Contents for CCI 1200
