CCI.TECU
– Set-up for operation
8
In accordance with ISO 11786, the signal connector is assigned the following
sensor data:
Wheel speed sensor:
It emits a specific number of electrical signals in
proportion to the wheel rotation. As such, the
theoretical speed of the tractor can be calculated.
Ground speed sensor:
It emits a specific number of electrical pulses in
proportion to the distance already covered. As such,
the real speed can be calculated.
PTO sensor:
It emits a specific number of electrical pulses in
proportion to the power take off speed. As such, the
power take off speed can be calculated.
3-point hitch sensor:
It provides an output voltage which is proportional to
the current position of the 3-point hitch.
Note
On a hardware generation 1 type terminal, CCI.TECU in this version can only
evaluate the signals of one of the two speed sensors.
With a terminal of hardware generation 2 or higher both speed signals can be
used simultaneously (see chapter 4.3.3.3).
Summary of Contents for CCI 50
