CCI.TECU
– Troubleshooting
37
Invalid value!
PTO speed exceeds 3000
rpm.
Number
of
pulses
per
rotation incorrect
Set the number of pulses
in the
Power Take Off
tab
PTO sensor defective
Replace PTO sensor
Invalid value!
Speed (ground speed sensor)
exceeds 85 km/h.
Number of pulses per 100 m
incorrect
Set the number of pulses
in the setting menu
Ground
speed
sensor
defective
Replace
ground
speed
sensor
Invalid value!
Speed (wheel speed sensor)
exceeds 85 km/h.
Number of pulses per 100 m
incorrect
Set the number of pulses
in the setting menu
Wheel
speed
sensor
defective
Replace
wheel
speed
sensor
Calibration error
Invalid min. value!
New min. position is the same
or higher that the saved max.
position. Ensure that the min.
position is reached and the
saved max. position is valid.
Calibration sequence was not
observed.
Ensure that you have carried
out the calibration in the
correct sequence.
If the problem occurs again,
please contact your specialist
dealer.
TECU changes to display
mode because another TECU
of higher priority was detected.
Please check the tractor
settings.
Another TECU is connected to
the BUS. It is present in another
terminal or in your tractor.
If the other TECU makes the
necessary information
available, then it is correct that
CCI.TECU changes into
passive mode.
If you want to make the
information available with
CCI.TECU, then you must
deactivate the other TECU.
You can find more information
about this in the relevant
instruction manual.
Connection to Control could
not be established.
Data transfer has been
activated, but CCI.TECU could
not connect to the Task
Controller.
Check the status of the Task
Controller being used
(normally CCI.Control),
Note
Other error messages may be displayed on the terminal that are dependent on the
implement.
A detailed description of the possible error messages and troubleshooting can be
referred to in the implement operating instructions.
Note
If the implement cannot be operated, check whether the "stop switch" is pressed in.
The implement cannot be operated until the button has been released.
Pos : 12 /CC-Is obus /*** * Seit enumbruc h * *** @ 8\ mod_1274446340522_0. doc @ 121469 @
Summary of Contents for CCI 50
