CCI.Command
– Introduction
7
1.3.4
Operation with implement
1.3.4.1
Non-ISOBUS-compatible
When operating with a non-
ISOBUS
enabled implement, the following functions
are available to you:
Parallel Tracking
after manual entry of the working width
Manual labelling of the worked area
1.3.4.2
ISOBUS enabled and task controller enabled
When operating with an
ISOBUS
and task controller enabled implement, the
following functions are available to you:
Parallel Tracking
(working width is automatically transferred)
Automatic identification of the worked area (working state of the implement is
transferred if an active task exists).
An
ISOBUS
and task controller enabled implement corresponds to the AEF
functionalities TC-BAS and TC-GEO (see chapter 8).
1.3.4.3
ISOBUS enabled and Section Control enabled
When operating with an
ISOBUS
and
Section Control
enabled implement, the
following functions are available to you:
1.
Parallel Tracking
(working width is automatically transferred)
2. Automatic identification of the worked area (working state of the implement is
transferred if an active task exists).
3. Automatic
Section Control
(geometry is transferred from the implement).
An
ISOBUS
and
Section Control
enabled implement corresponds to the AEF
functionality TC-SC (see chapter 8).
Summary of Contents for CCI 50
