CCI.Command
– Operation
33
4.3.4.1
Enter working width
To enter the working width, proceed as follows:
1. Press on the "Working width" button on the
touchscreen
or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2.
Enter the value on the
touchscreen
using the number pad or the slider.
3.
Confirm your entry with "OK".
Note
The value entered for the working width must be as accurate as possible to enable
an exact calculation of the worked area.
The valid range for the working width is between 0.0 and 99.0 metres.
Note
If the working width is transferred from the implement, the button is greyed out.
Manual entry is not possible.
The implement working width is displayed in the Section geometry view (see
chapter 4.3.3.1).
To change the working width, implement operation must be called. You can find
more information in the operating instructions for your implement.
Summary of Contents for CCI 50
