CCI.Command
– Operation
34
Overlapping
The
Overlap
setting is used to compensate for steering faults and
GPS
inaccuracies.
There are 2 possible applications:
1.
Missed areas
must be avoided.
In this case a positive value must be entered. This results in the distance
between the
lead tracks
being reduced by the entered value. This reduces the
effective working width,
missed areas
are avoided and
overlapping
can occur.
2.
Overlapping
must be avoided.
In this case a negative value must be entered. This results in the distance
between the
lead tracks
being increased by the entered value. In this way
overlapping
is avoided and
missed areas
can occur.
.
4.3.4.2
Enter the overlap value
Proceed as follows to enter the
Overlap
value:
1. Press on the "Overlap" button on the
touchscreen
or turn the scroll wheel until
the button is highlighted in white and then press on the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2.
Enter the value on the
touchscreen
using the number pad or the slider.
3.
Confirm your entry with "OK".
Note
Values between -100 and +100 cm are valid for the
overlap
.
Summary of Contents for CCI 50
