CCI.Command
– Operation
44
4.3.5.2
Select the degree of overlap
To select the degree of overlap, proceed as follows:
1. Press on the "Degree of overlap" button on the
touchscreen
or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
→ A selection list opens.
2. Select the desired setting from the list. To do so, on the
touchscreen
press the
button with the degree of overlap or turn the scroll wheel until the button is
highlighted in white and then press on the scroll wheel.
→ The degree of overlap appears in the selection window.
3. Confirm your selection by pressing "OK" or pressing the button with the degree
of overlap again or by pressing the scroll wheel.
Caution!
At field boundaries, 0 % degree of overlap applies as a matter of course.
Summary of Contents for CCI 50
