CCI.Command
– Operation
47
4.3.5.3
Enter the overlap tolerance value
Proceed as follows to enter the overlap tolerance value:
4. Press on the "Overlap tolerance" button on the
touchscreen
or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
5.
Enter the value on the
touchscreen
using the number pad or the slider.
6.
Confirm your entry with "OK".
Note
Values between 0 cm and half of the outer section are valid for the overlap
tolerance.
Summary of Contents for CCI 50
