CCI.Command
– Operation
48
Degree of overlap and tolerance at field boundaries
For safety reasons, a 0% degree of overlap always applies at the field boundary.
Under you own responsibility, the overlap tolerance for the field boundary can be
set separately.
GPS drift
can cause switching on and off of the outer section at the field
boundaries (see also the infobox about overlap tolerance on page 46). The user
can minimise this switching on and off by entering an overlap tolerance at the field
boundaries.
A setting greater than 0 cm can result in working beyond the field boundary. The
recommended setting is 0 cm!
If you deviate from the recommended value, you must check whether working
beyond the field boundary is acceptable.
4.3.5.4
Enter the overlap tolerance at field boundary
Caution!
Check carefully whether treatment beyond the field boundary is acceptable!
Once the work is carried out, the setting must be set back to 0 cm.
Proceed as follows to enter the overlap tolerance for the field boundaries:
1. Press on the "Overlap tolerance at field boundary" button on the
touchscreen
or turn the scroll wheel until the button is highlighted in white and then press
on the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2.
Enter the value on the
touchscreen
using the number pad or the slider.
3.
Confirm your entry with "OK".
Note
Values between 0 cm and half of the outer section are valid for the overlap
tolerance.
Summary of Contents for CCI 50
