CCI.Command
– Operation
77
4.4.11 Switch on/off manual highlighting of the area travelled over
If no ISOBUS implement is connected, then no information about the already
worked area is available. The worked area can be highlighted manually.
To switch the manual marking of the travelled over area on or off, proceed as
follows:
1. Press the "Marking on/marking off" button (F6) on the
touchscreen
.
→ The travelled over area is highlighted / no longer highlighted in blue on the
map.
→ The button F2 changes from "Selection on" to "Selection off" and vice-
versa, dependent on which function has just been chosen.
To change between manual mode and Section Control auto mode, proceed as
follows:
1. Press the "Auto mode" or "Manual mode" button (F6) on the touchscreen.
→ The mode changes and the symbol on the F6 button changes.
Note
This function is only available if no implement data is transferred or Section Control
has not been activated.
Note
It is necessary that the working width is already entered for a correct display of the
worked area, (see chapter 4.3.4.1).
Summary of Contents for CCI 50
