CCI.Command
– Troubleshooting
80
Error
Possible cause
Rectification/approach
In spite of calibration, the
position of the field boundary is
not correct.
Reference point is not
correctly approached.
Check the position of the
tractor, approach the
reference point again.
Position of the
GPS
aerial
on the tractor is changed
after setting.
Check the position of the
GPS
aerial and, if
necessary, enter again (see
operating instructions
CCI.GPS
).
Poor
GPS
signal quality.
(see next point)
The implement switches on
and off too early/late.
Poor
GPS
signal quality
Check the signal quality,
drive out of any shadow
region (if necessary
recalibrate any reference
point).
Incorrect geometry settings
Refer to the implement
operating instructions to see
how these can be changed.
Incorrect setting of the
position of the
Connection
point
/aerial
Re-measure and check the
settings in
CCI.GPS
.
Check the selection of the
Connection point
in
CCI.Command
.
Incorrect
delay times
If these are transferred from
the implement, consult the
implement operating
instructions
If these were set by you,
verify the
delay times
. To do
this work a strip and mark
the outer worked edge e.g.
with barrier tape. Drive over
this strip at a 90° angle and
measure how many cm the
implement was switched off
too early/too late. Divide this
value (cm) by the average
speed in the headland area
(cm/ms) (e.g. 8 km/h
corresponds to 0.22
cm/ms). This correction
value must be added to the
set value if switching off is
too late and subtracted from
it if switching off is too early.
Summary of Contents for CCI 50
