CCI.Command
– Troubleshooting
82
5.3 Buttons are greyed out
Button
Possible cause
Rectification
Multiple buttons in the map
view
(obstacles, set field
boundary, manual marking, set A-
point, auto mode)
Software was not activated
Check whether the
licence key has been
entered.
Tabs: Parallel Tracking Settings
(all buttons)
Software was not activated
Check whether the
licence key has been
entered.
Tabs: Section Control Settings
(all buttons)
Software was not activated
Check whether the
licence key has been
entered.
Enter delay times
Delay times
are defined by the
ISOBUS
implement and are
displayed automatically.
For a few implements, the
delay times
can be set in
the menu. Refer to the
operating instructions of
your implement to find
them.
Enter working width
Working width is transferred by
the
ISOBUS
implement and
automatically displayed.
see above
Enter value for headland
distance (dashes appear in the
field)
The connected implement does
not correspond to class 5
(fertilizer)
The headland distance
only fulfils its purpose with
fertilizers. According to
the ISO standard,
fertilizers conform to class
5. Transferred. If the
implement is of another
class, then the headland
distance is not available.
Enter value for headland
distance ("ISO" appears in the
field)
The connected implement
transfers a value for the working
depth of the individual sections.
The headland distance is
not required. The
implement determines via
the working depth at
which points the sections
can be switched on and
off.
Start Section Control
The connected implement is not
ISOBUS
and
Section Control
enabled.
Summary of Contents for CCI 50
