CCI.GPS
– Operation
11
4.3.1
Select GPS source
To select the GPS source, proceed as follows:
1. Press on the "GPS source" button on the touchscreen or turn the scroll wheel
until the button is highlighted in white and then press on the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
→ The following selection list opens:
2. Select the desired GPS source in the selection list. To do so, on the
touchscreen press on the button with the GPS source or turn the scroll wheel
until the button is highlighted in white. The GPS source then appears in the
selection window.
3. Confirm your selection with "OK" or press once again on the GPS source
highlighted in white.
Serial or CAN connection of a GPS receiver
There are two options for connection of a
GPS
receiver:
If the receiver has a serial output, then this is connected to the RS232-I input of the
terminal
and this input is selected as the source.
If the receiver has a CAN-Bus line connection option, then this is connected to the
ISOBUS
and in the CCI.GPS, CAN-Bus must be selected as the source.
Summary of Contents for CCI 50
