CCI.TECU
– Operation
18
4.3.3
Detailed view
The detailed view of a tractor is divided into 6 tabs: Overview, Comment, Tractor
Settings, Speed, Power take off and 3-point hitch.
The tabs Speed, Power take off and 3-point hitch are not always available:
The speed tab is only available if, in the tractor settings, the signal connector
has been selected as the signal source for the wheel or ground speed sensor.
The Power take off tab is only available if the signal connector has been
selected as the signal source for the power take off speed in the tractor settings.
The 3-point hitch tab is only available if, in the tractor settings, the signal
connector has been selected as the signal source for the 3-point hitch.
These are organised as follows:
Overview:
This shows the speed settings, PTO settings and the
3-point hitch settings.
Comment:
This shows a comment with a maximum of 160
characters.
Tractor settings:
This shows the tractor name and the settings for
wheel speed sensor, ground speed sensor, PTO
sensor and 3-point hitch sensor.
Speed:
Shows how many pulses per 100 metres are output
by the sensor.
Power take off:
This shows how many pulses are emitted by the
sensor per power take off revolution.
3-point hitch:
This shows the voltage values for the maximum and
minimum position.
To switch between tabs, proceed as follows:
1. Press the corresponding tab on the touchscreen or select it using the arrow
keys (F8, F2).
Summary of Contents for CCI 50
