CCI.TECU
– Operation
23
Note
If you select the signal connector as the signal source for the wheel speed sensor
or the ground speed sensor you must calibrate the speed or manually enter the
pulses per 100 metres.
More detailed information on speed calibration can be consulted in chapter 0.
Note
If you select the signal connector as the signal source for the 3-point hitch sensor
you must calibrate the 3-point hitch.
More detailed information on the 3-point hitch calibration can be consulted in
chapter 4.3.3.6.
Note
If you select the signal connector as the signal source for the PTO sensor you must
enter the pulses per revolution.
4.3.3.3.3 Activate power management
To activate the switch off delay, proceed as follows:
1.
Press the “Power management” button on the touchscreen or turn the scroll
wheel until this button is highlighted in white and then press the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2. Enter the Boolean value.
3. Confirm your entry with "OK".
Note
The delayed switch off is available for all terminals from hardware generation 2.
Note
This function can only be used if the tractor is equipped with the CCI ISOBUS IRB
upgrade cable set.
4.3.3.3.4 Enter the switch off delay value
Proceed as follows to enter the maximum switch off delay value:
1. Press on the "Max. switch off delay" button on the touchscreen or press on the
scroll wheel or on the "OK" button (F6).
2. Enter the new value on the touchscreen using the number pad or the slider.
3. Confirm your entry with "OK".
Note
The Max. switch off delay can take any value between 0 and 250 min.
Summary of Contents for CCI 50
