CCI.Control
CCI.Control
–
Introduction
3
Pos : 1 /CC-I sobus/Ei nlei tung @ 8\ mod_1273561492335_6. doc @ 119978 @ 1
1 Introduction
1.1 About these operating instructions
These operating instructions are intended as an introduction to the operation and
configuration of the CCI.Control app. This app is preinstalled on your ISOBUS CCI
100/200 terminal and can only be run there. It is only with knowledge of these
operating instructions that accidental misuse of the terminal can be avoided and
fault-free operation ensured.
These operating instructions must be read and understood particularly prior to
editing of tasks using the software, to prevent problems during operation.
1.2 Reference
These operating instructions apply to CCI.Control v4.
In order to check the version number of CCI.Control installed on your ISOBUS CCI
terminal, proceed as follows:
1. Press the home key to enter the main menu.
2. Press the "Settings" button (F1) in the main menu.
3. Select the tab
Info and Diagnostics
.
4. In the
Info and Diagnostics
tab press the button "Terminal".
5. Press the "Software" button on the touchscreen.
→ The version of the terminal software component is indicated in the
information field that is now displayed.
1.3 About CCI.Control
In accordance with the ISOBUS standard, CCI.Control is a task controller software
package which, amongst others, fulfils the requirements of the AEF functionalities
TC-BAS and TC-GEO (cf. Section 8).
1.3.1
Components
CCI.Control is used for documentation and task management:
Data interface
The ISO-XML format, defined for ISOBUS, is used
for data exchange. Data are transferred using a
flash drive or via online transfer.
Implement interface
Process data acquisition and implement control are
achieved via the ISOBUS.
The job computer for the implement must therefore
be equipped with task controller software.
Summary of Contents for CCI 50
