Technical instructions
MPZ
v1.1
www.ccei.fr
12
6. Operation
6.1. Start-up
After configuring the desired marker and operating modes, you can power up the installation.
As soon as it is powered up, the smart controller for piezoelectric switch MPZ must switch on. A
colour gradient is then seen on the RGB lighting of the piezoelectric button (if available), followed
by a reminder of the marker operating mode (see 5.1 - column 6) by four flashes.
The module and the RGB lighting of the button then assume their initial status, corresponding to
the "Seq 1" column of the table in 5.2, regardless of the selected mode.
After the sector is cut, the device will always re-start in this status ("off").
6.2. Use
With each impulse received from the piezoelectric button, and whenever the local control is pressed,
the module will advance in its sequences according to the table in 5.2.
Once the final sequence is reached, the module resumes its initial status on the next command (Seq.
1).
If a time out is selected, whenever the piezoelectric button or the local command is pressed, a timer
is launched according to the requested duration. At the end of this timer, if no activity is detected,
the MPZ module returns to its initial status (Seq. 1).
