13
Dial #
0000 + 9000 L K #
Where, L = Length of new numbers
– 3 digits or 4 digits
K = First digit of the new numbering. If K=2 then the numbering will become 201 (or 2001)
Onwards. Then all those Numbers can be changed through the following programming.
Default: 601,602, to 632
.
GSM Card Setting
.
When GSM Card is used. Two GSM cards replace Trunk 1 and Trunk 2 in the system respectively.
When using 1 GSM Card, Connect at GSM-CARD-1. Open Jumper JM3 in Main Card.
Make sure the two jumpers on GSM Card are shorted. Else the GSM card will not work.
Similarly, for GSM-2, open jumper JM4.
.
GSM Volume Setting
.
To set GSM card speech volume,
Dial: #*0000 + 495 G XX#
Where G = 1 for GSM1, 2 for GSM2
XX = volume level (01-99) lower value has lower volume
Default: 99
.
GSM Signal Strength Checking
To check GSM signal Strength-
Dial: #5G
Where G = 1 for SIM 1, 2 for SIM 2
After Confirmation tone onhook the Ext, once GSM strength is received from GSM card it is displayed on LCD of ext.
.
Hold Music
.
There are 3 type of Hold Music in the PBX. Any one of them can be assigned or they all can be assigned to play.
Internal Hold Music
This is default setting for Hold Music.
SD Card Hold Music (Optional) ( Also Refer to SD Card programming for enabling and mode setting )
Hold music can be played via SD card, for setting see SD Card Playing Modes
Format SD-Card with FAT16/FAT32 format and make a folder named-
02
Put the file with File name in folder 02-
•
001-Hold Music.mp3
(This file will play in loop continuously)
Note- File name before - (dash) is fixed after that it can be any name and file extension must be
.mp3
External Hold Music
External Hold music can be connected to the PBX by terminating the external source on 3 Pin Stereo Jack marked as
“Music” on the PBX side panel. On inserting a 3 Pin Stereo Jack, the internal source gets disconnected.
.
Hot Line to Junction
.
Some or all extensions can be programmed to get Junction Line on lifting the Handset.
To dial internal numbers, dial
on lifting the Handset. You will get internal dial tone of the PBX.
To program an extension to get a free Junction line on lifting handset,
Dial #
0000 + 20 NN#
Where, NN= last 2 digits of Extension numbers that is to be programmed for Direct Junction Access.
Dial #
0000 + 20 # -
To convert all Extensions in “Hot Line to Junction” mode
Dial #
0000 + 21 NN # - To convert NN Extension in normal mode.
Dial #
0000 + 21 # - To convert all Extensions in normal mode.
Note
:
When all Extensions are converted to Hot Line then to get into the Programming mode, lift Handset
– dial
#
0000
+ Whatever Programming to be done.
Default: Normal Mode
.
Hot Line to Extension
.
Some or all extensions can be programmed to get connected to an Extension, on lifting the Handset.
To dial internal numbers, dial
on lifting the Handset. You will get internal dial tone of the PBX.
To program an extension in this mode,
Dial #
0000 + 883 NN XXXX#
