2. Specifications
2-1 Specifications
Model
PDS-30
Input voltage
100 to 240V AC
Input power
46W 110VA max. (at 100V AC)
Frequency
50/60Hz ±10%
Inrush current
50A max. (at 100V AC)
Leakage current
0.75mA max.
Output voltage
By selecting output selector switch, either 12V or 24V lights may be connected.
Continuous Light: 12.0 ± 0.1V or 24.3 ±0.2V
Strobe Light: 18 ± 1V or 48 ± 1V
Output power
30W max.
Mode selection
DIP switches on the front panel
Control method
Continuous Light: Pulse duty control Frequency (50kHz)
Strobe Light: pulse width and pulse duty, AND type
Light control
Manual: Front panel rotary switch
Remote: RS-232C (9-pin D-Sub) or Bit-parallel signal (15-Pin D-Sub)
Resolution : Continuous Light (256levels) Strobe Light (128levels)
Input-output control Terminal block: Strobe trigger, Constant light ON/OFF
15-pin D-Sub: Light control date input (8 bit), Writing signal, Trigger, ON/OFF input
non-insulated, Internally pulling up to +5 V power supply by
resistance, Light emitting output timing, Trigger delay output
(Nte3)
Input level: 5V CMOS input, Pull up 4.7k, -0.5 to +5.5V max.
RS-232C
Pulse duty control, Strobe light pulse width, Strobe light pulse delay,
Trigger Output Delay
(Nte3)
Data bit length: 8 bits, Stop bits: 1 bit, Parity check: None, Baud rate: 9,600 bps fixed.
Output connector
SMP-02V-BC (mfd. by JST) 1:OUT+(+12V), 2:OUT-
SMP-03V-BC (mfd. by JST) 1:OUT+(+24V), 2:NC, 3:OUT-
SMP-04V-BC (mfd. by JST) 1:OUT+(+24V), 2:OUT+(+12V), 3:OUT-, 4:Fan GND
Insulation
Between input and output connectors, between input connector and frame ground:
500V DC, 20 M min
Between output connector and frame ground: 50V DC, 10 M min
Dielectric
Between input and output connectors, between input connector and frame ground:
1,500V AC for one minute (10mA)
Operating
environment
- Temperature: 0 to 40 °C, humidity: 20 to 85%RH (with no condensation)
- Altitude: 2,000 m max.
- Protective ground class I
- Pollution level: 2
- Installation category II (restricted to use in indoor environments)
Storage
environment
Temperature: -20 to 60°C, humidity: 20 to 85%RH (with no condensation)
Applicable
standards
LVD: EN61010-1
EMC: EN61000-6-2, EN61000-6-4
Cooling method
Natural air cooling
Dimensions
(Nte2)
W62 x H110 x D170 mm
Weight
1.2 kg max.
Notes
1: The operating voltage range is 85 to 264V AC of the input voltage.
2: Product items such as the switch, latch and stand are not included.
3: Trigger delay output is externally synchronized signal (100
µ
s fixed pulsation width)
