7
The indicating information request users input the channel number of setting up protocol
and baud rate. The keyboard default channel number is “888”, it means that to set up all
channels with same protocol and baud rate. Users should change “888” into the relative
channel number if there are some particular channels requested, channel scope:”1~128” .
②
Set up protocol and baud rate
After the channel is set up, press [ACK] to enter into setting up status of protocol and
baud rate, then the LCD indicates:
The indicating information indicates the present protocol and baud rate.
The keyboard offers 5 protocols for users to choose
( PELC-D,PELCO-P,PELCOD1,PELCOP1,NEW) , press [PREVIEW] or [PRESET] button
to choose the suitable protocol. After the protocol finish setting up, press [F1/ON] to switch
the cursor to status of setting up baud rate. The baud rates can be set up by the keyboard
are: 1200, 2400, 4800, 9600, 19200. Press [PERSET] or [PREVIEW] to choose suitable
baud rate.
③
Save the present setup of protocol and baud rate
After finish setting up protocol and baud rate, press[F2/OFF] button to save the present
setup to the keyboard .The keyboard is back to input new channel number status .
④
By operation of step
,
,
,different protocol and baud rate of particular
② ③ ④
channels can be set up , after all these setup are finished, press [EXIT] to exit the setup
status.
8.3 Left /Right delimitation setup
①
Left/Right delimitation setup
Press [FUN] repeatedly to make the LCD indicates:
Press [ACK] button to enter into Left/Right delimitation setup status.
②
Set up Left delimitation
Protocol: PELCO_D
Baud Rate: 2400
3) Limits Setup
