28
REVEX
2PH from 120A to 210A
User’s manual
9.4 Parameter list
Control Panel Display and Keys are Not present for Option Codes: 1/2/3/7
(see table pag. 15)
This chapter describes the parameter on the menus accessed via the control panel and Configurator software.
To learn how to access the menus described below see “Menu navigation” chapter.
Menu Listing
The table below lists the parameters found on each menu. See the following pages for descriptions and other
details of each parameter.
Operator
Setup
Advanced Setup
Hardware
Communication
Monitoring
Set Point
Out Scale
Firing Type
Analog in 1
Port 1 Baud
Dig in 1
Volts Out
Nom Line V
Min Cycle
Analog in 2
Port 1 Addr
Dig in 2
Current
Nominal I
Cycle Time
An2 Funct
Watchdog
Enable
Power
SP Select
Feedback
DI1 Functn
WD Reset
SP Source
Volts In
Pb Power
DI2 Functn
Analog In1
Frequency
Ti Power
Alm Out Fn
Analog In2
Pwr Factor
HB Sense
Start Disp
SW Ver
Load Ω
HB Delay
SW Rel
Out Scale
Unit Type
Nom Line V
Max Voltage
Nominal I
Max Current
Aux Voltage
Serial No.
SCR Temp
Read/write Read only