CDA ci522, Manual For Installation, Use And Maintenance

7

•

   Select correct heat position. 

•

   Set the timer to the correct position (See programme around the 

timer on fascia panel).

•

   For energy labeling purposes (EN61121:2005) for a cotton dry load, 

use the maximum load weight for cotton and set the timer to the 
recommended drying time for cotton dry as specified on the control 
panel.

•

   The standard cotton programme used at full and partial load is the 

standard drying programme to which the information in the label 
and the fiche relate.  This programme is suitable for drying normal 
wet cotton laundry.  It is the most efficient programme in terms of 
energy consumption for cotton

•

   Your appliance is a reversing, small door opening, dryer.  A full load 

will typically take 130 minutes and will use approximately 4.48kWh 
of electricity.  A half load will typically take 75 minutes and will use 
approximately 2.32kWh of electricity.

•

  Press the start button.

•

   The drum will now begin to rotate and will stop automatically when 

the timer reaches the “0” position.

•

  Once the clothes are removed, clean the filter.

•

  Switch off the electricity supply.

Should the clothes become dry before the cycle has finished the 
thermostat will automatically switch off the heater to prevent over 
drying and save energy although the drum will still rotate.

When drying large items, such as sheets, we suggest you stop the 
dryer periodically to redistribute the load.