30
Troubleshooting
All repairs which must be done on the machine should only be
performed by authorised service agents. When a repair is required for
your machine or you are unable to eliminate the failure with the help
of the information given below:
• Unplug the machine.
• Close the water tap.
• Contact CDA Customer Care.
Fault
Probable cause
Methods of elimination
The machine will not
start.
It is unplugged.
Insert the plug into the socket.
The fuse is damaged.
Replace the fuse.
There is a fault with the power
supply.
Check the power supply.
The washer door is not properly
closed.
Close the washer door.
“Start” button has not been
pressed.
Press the “Start” button.
“Programme selector” knob is not
set correctly.
Set the “Programme selector” knob
correctly.
The machine does
not filll with water.
“Start” button has not been
pressed.
Press the “Start” button.
Water tap is not turned on.
Turn on the water tap.
Water pressure too low.
Check water pressure.
The inlet hose is kinked.
Check the inlet hose.
Water supply failure.
Check the water supply.
“Programme selector” knob not
set correctly.
Set the “Programme selector” knob
correctly.
Washer door not properly closed.
Close the washer door properly.
Inlet hose filter is blocked.
Unblock the inlet hose filter.
The machine is
draining while being
filled.
The height of drain hose is too
low.
Install drain hose at the specified height.
The drain hose is in water.
Ensure the drain hose end is not
immersed in water.
Summary of Contents for ci860
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...