4
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the
control panel markings.
You can clean your extractor effectively by simply using a dilute solution of water and mild detergent and drying to a
shine with a clean cloth, for example the CDA E-Cloth.
Cleaning the grease filter
The grease filter should be kept clean to minimise the risk of fire.
At least once a month you should remove and clean the grease filter with hot soapy water.
To remove the grease filter, follow the steps below:
1. Remove the cover panel by pushing the fixing clips up and then lifting the panel forwards.
2. Remove the filter retaining wires from the cover panel.
3. Remove the grease filter and wash by hand in a lukewarm solution of water and mild detergent. Once clean squeeze the
grease filter but DO NOT wring it out. Clean the filter holder using a dilute solution of water and mild detergent or with a
damp cloth. Allow the grease filter to dry completely before reassembling the extractor.
4. Replace the grease filter in the cover panel and reattach the filter retaining wires.
5. Replace the cover panel by inserting the lugs on the upper side in the extractor, and then refasten the fixing clips on the
lower side.
Changing the charcoal filter (re-circulating only)
To ensure best performance of your extractor, you should replace the charcoal filters every four to six months,
depending on use.
Please note the charcoal filter cannot be washed.
To attach a new charcoal filter, follow the steps below:
1. Remove the cover panel as described above.
2. Place the charcoal filter on the centre of the motor support, and once firmly located turn the charcoal filter clock
wise 90ºC until the charcoal filter locks into position.
3. Replace the cover panel.
