22
Changing the Light
IMPORTANT: DO NOT PERFORM MAINTENANCE OR ATTEMPT
TO CLEAN THE EXTRACTOR WITHOUT FIRST SWITCHING OFF
THE ELECTRICITY SUPPLY.
Synchronising the remote control with the extractor
When the extractor is off, press and hold button “B”, and then switch
the extractor on.
After five seconds release button “B” and the display will light up in
sections. Then press button “E”.
“TC” will flash twice to confirm the remote is synchronised.
“TC” will flash once to confirm the remote is not synchronised.
To change the battery
The remote control is powered by two standard LR03-AAA batteries.
To open the battery compartment, slide the rear panel down and then
lift the panel.
To replace the rear panel, locate the panel over the battery
compartment then slide the panel up until it clicks.
Summary of Contents for EVX101
Page 21: ...21 Typical Installation Examples ...
Page 26: ...26 ...