8
To reset the filter alarm, press button “E”
for approximately 3 seconds when the
extractor is switched off.
To remove the grease filters follow the
steps below:
1. Open the stainless steel cover panels
by pulling them down and outwards
on either side. They will remain
located in their hinges.
2. Pull open the handle on each grease
filter as shown in fig. 3. It will release
at the handle side. Then lower the
grease filter to remove it completely.
To replace the grease filters, repeat the
above steps in reverse.
Please note:
Cleaning the grease filters in the
dishwasher may lead to discolouration.
This is normal and does not constitute a
fault with the appliance.
Changing the charcoal filter
(re-circulating only)
After 200 hours of use “EF” will show
on the display when the extractor is
switched off. This indicates that you
fig. 2
fig. 3
Summary of Contents for EVX101
Page 21: ...21 Typical Installation Examples ...
Page 26: ...26 ...
