CDA EVX110, Installation, Use And Maintenance Manual

7

  approximately six minutes before returning to speed 3. This is not a   
  fault. See page 21 for more information.
-  To activate the intensive function increase the speed using the 

remote control until the LED indicator on the extractor turns red.

-  To cancel the intensive function, press button 4 to change/lower the 

speed level or press button 2 to switch the extractor off.

Extractor lights 

-  To switch the lights on and off, press button 5 on the remote control.
-  The lights on this extractor are dimmable between 20% and 100% 

intensity. To adjust the lights, first switch them on as above. Press 
and hold button 5 for a maximum of approximately 5 seconds or until 
the desired intensity is achieved. After approximately 5 seconds the 
lights will be at 20% intensity. 

Please note

 that the lights will be at 100% intensity each time you 

switch them on.

Timer 

The extractor is equipped with a timer that allows the extractor to run 
for 10 minutes before switching off automatically. 
-  To activate the timer, set the desired speed and press button 3. The 

LED indicator on the extractor body will flash to confirm the timer is 
active.

- To cancel the timer, press button 3 on the remote control.

Please note 

that the timer can be activated when the intensive 

function is on, but the intensive function will still switch to speed 3 
after 6 minutes. Speed 3 will switch off after the remaining 4 minutes.