Before first use
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda
and warm water and then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as the appliance cools.
Please note:
•
The appliance will work continuously until it comes down to the correct temperature.
•
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary
damage to the compressor.
This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places.
•
The plug should be fully accessible at all times.
•
To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
•
The cooling system at the rear of the appliance must not touch the rear wall.
•
The appliance must be installed with adequate ventilation. Ensure that there is 15 cm clearance above the appliance,
and that there is space between the rear of the appliance and the wall.
Reversing the door
It is possible to reverse the door on this refrigerator, if required. To do so, follow the steps below:
1. Carefully tilt the appliance to allow access to the base of the appliance.
2. Remove the height adjustable feet.
3. Remove the lower hinge plate.
4. Lift off the door and carefully put it to one side.
5. Remove the top hinge plate. Change the hinge pin on the plate over and then replace the hinge plate on the
alternate side of the door frame.
6. Remove the hinge pin receiver and blank at the top of the door and replace on the alternate side.
7. Relocate the door on the top hinge pin.
8. Refit the lower hinge plate.
9. Refit the height adjustable feet.
