4
Before first use
You must allow the fridge to settle for at least twenty four hours
prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to first
use, using a solution of bicarbonate of soda and warm
water and then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as the
appliance cools.
Do not load the appliance with food until it reaches the required
temperature
Please note:
The appliance will work continuously until it comes down to the correct
temperature.
If the appliance is switched off, you should allow five minutes before
switching it on again to prevent unnecessary damage to the
compressor.
The fridge and freezer shelves can be moved according to storage
requirements.
To move the shelf, pull the shelf outwards until the shelf stops
(approximately one third out) then lift up the front section slightly and pull
the shelf out. To replace, slide the shelf back into the slot, and then lower the
front section before pushing fully back into position.
fig. 1
