CDA WC370, Manual For Installation And Use

Please note:  You should ensure that there are no dishes in the upper basket when running a lower basket 
half-load programme, and none in the lower basket when running an upper basket half-load programme.

If you have selected any extra function (3 in 1, prewash, half-load) for a programme, this function will 
automatically be selected the next time the dishwasher is used. To cancel the selection of any extra function, 
press the specific extra function button (5, 6 or 7) until the indicator light for that function goes out.

Starting a programme

• 

Press the Power button (the end of programme light will be switched on)

• 

Press the Programme Selection button until the required programme is shown on the display.

• 

If required, set the delay timer by pressing the Delay Timer button

• 

Once a programme is selected, the end of programme light will switch off.

• 

When you close the dishwasher door, the programme will start automatically.

Please note: The dishwasher stores the most recently used programme in its memory.  To change the 
programme, simply press the Programme Selection button.

At the end of a programme

If possible, do not open the dishwasher door once the programme has started.
At the end of a programme, the dishwasher will beep five times, and the end of Programme Indicator light will switch on.

Changing a programme

It is possible to change the programme if necessary once the programme has started.

• 

First open the door slightly to reduce the risk of water spillage.

• 

Press the programme selection button until the required programme is shown on the display.

• 

Then close the door.  The dishwasher will begin the new programme from the point at which the old programme stopped.

Cancelling a programme

It is possible to cancel the programme once is has started.

• 

First open the door slightly to reduce the risk of water spillage.

• 

Press and hold in the Programme Selection button for three seconds until the end of programme indicator flashes and  

a “1” shows on the display.

• 

Then close the door.  The dishwasher will run a drain cycle which will take approximately 30 seconds.  Once this is    

complete, the dishwasher will beep five times and the end of programme light will switch on. 

Switching the dishwasher off

• 

Once the dishwasher beeps five times and the end of programme light switches on, the dishwasher can be switched off  

by pressing the Power button.  

• 

Then turn off the water tap and remove the plug from the power socket.

Please note:  the dishwasher will automatically continue on the programme it has started if the door is 
opened or in the event of a power cut.

4