12
ENGINE OIL REPLACEMENT
1.
Place the machine on a level surface and warm up the engine for
several minutes. Then stop the engine and turn the fuel cock knob
to
OFF
. Turn the fuel tank cap air vent knob clockwise.
2.
Loosen the screw and remove the cover.
3.
Remove the oil filler cap
4.
Place an oil pan under the engine. Tilt the generator to drain the oil
completely
5.
Replace the generator on a level surface.
6.
Add engine oil to the upper level.
7.
Install the oil filler cap
8.
Install the cover and tighten the screw
⚫
Recommended engine oil:
1.1 L
.
API Service
SJ
CAUTION:
⚫
Be sure no foreign material enters the crankcase.
⚫
Do not tilt the generator when adding engine oil. This could result in
overfilling and damage to the engine
⚫
Clean the oil filter every other 100hr.
AIR FILTER
Maintaining an air cleaner in proper condition is very important. Dirt
induced through improperly installed, improperly serviced, or inadequate
elements damages and wears out engines. Keep the element always
clean.
1.
Remove the cover.
2.
Remove the air filter cover and element.
3.
Wash the element in solvent and dry.
4.
Oil the element and squeeze out excess oil. The element should be
wet but not dripping.
5.
Insert the element into the air filter.
6.
Install the cover
UPPER
LEVEL
32¡ ã
F
F
80¡ ã
25¡ ã
C
C
0¡ ã
or 10W-30
SAE #30
or 10W-40
SAE #20
or 10W-30
or 10W-40
or 10W-40
or 10W-30
SAE 10W
