During power failure, you may extend the backup time to critical devices by setting shorter
backup time for non-critical devices.
Step 4: Communication connection
Communication port:
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB/RS-232port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule UPS
shutdown/start-up and monitor UPS status through PC.
The UPS is equipped with intelligent slot perfect for either UPO SNMP or SNMP web card
box or CDP AS400 card (dry contacts). When installing either UPO SNMP or SNMP web card
box or CDP AS400 card (dry contacts) in the UPS, it will provide advanced communication
and monitoring options.
Step 5: Network connection
Network/Fax/Phone surge port
Connect a single modem/phone/faxline into surge-protected “IN” outlet on the back panel
of the UPS unit. Connect from “OUT” outlet to the equipmentwith another
modem/fax/phone line cable.
Step 6: Disable and enable EPO function
This UPS is equipped with EPO function. By default, the UPS is delivered from factory with
Pin 1 and pin 2 closed (a metal plate is connected to Pin 1 and Pin2) for UPS normal
operation. To activate EPO function, remove two screws on EPO port and metal plate will
be removed.
Note:
The EPO function logic can be set up via LCD setting. Please refer to program 16 in
UPS setting for the details.
Step 7: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not
expect full battery run capability during this initial charge period.
Summary of Contents for UPO11-1RT
Page 14: ...2 Battery kit 3 Battery kit...
Page 15: ...4 Battery kit 5 Battery kit...
Page 17: ......
