CDVI GALEOR, Installation Manual

GALEOR

Illuminated RF Keypad

  INSTALLATION MANUAL

6] PROGRAMMING

GALEOR FACTORY SETTINGS: 

- No user codes. 

- Buzzer ON

- Time-out backlit:

 3 Sec. 

- Transmission time-out: 

25 seconds

- Factory master code:

1 2 3 4 5.

- Programming time-out: 

10 seconds.

- Channel choices:  

 Channel 1 = A,

 Channel 2 = B.

AUDIBLE FEEDBACKS: 

1 beep: Power-up (battery insertion)

 1 long beep:

  - Enter on menu,

  - Validation of a programming choice,

  - Exit from a menu choice.

 2 beeps: Confirm enter in factory recovery

 3 beeps: confirm factory recovery “A+1”

 4 beeps:

  - Confirm factory recovery “B+3”,

  - Error for wrong channel,

  - Error for insertion of a code already

    Memorized.

USING RULES AND USER CODES:

- All the buttons can be used to  

  compose the personal access code,  

  except A and B. 

- The master code must be composed  

  by 5 digits.

- The user codes can be composed by 

4 or 5 digits according to initial setting 

- The master code cannot be used as  

  transmission code.

EN

10

cdvigroup.com

1 beep

Error message if the 

Master code typed 

corresponds to User 

code in memory 

1 beep = OK 

(4 beeps = Error)

Type the 5 digits of 

the new Master code

A0

Change

Master code

1 beep

Error message if the User 

code typed corresponds to 

a user code in memory 

 -------- or --------

the memory is full 

 -------- or --------

is 12345

1 beep = OK 

(4 beeps = Error)

Then press :

-“A” = Only channel 1

-”B” = Only channel 2

-”A & B” = Channel 1

  or Channel 2

A1

User code 

programming

Type the digits

of the USER CODE

Press “0” to confirm

The keypad comes without any setting for the user digit 

number. At the battery insertion the 12 leds start to 

blink, waiting for this setting. 

 PRESS the 

key 4

 for 

4 sec

. to set 4-digits 

user codes

 --> 4 beeps

 PRESS the 

key 5

 for 

5 sec

. to set 5-digits 

user codes

 --> 5 beeps

After this setting, the keypad will accept only user codes 

composed by 4 or 5 digits, according to the choice made.

If no change is done (change of the master code, user 

code memorization, etc) just by removing the battery 

the keypad comes back the factory settings and requires 

again to set the number of digits. 

Once set the number of digits and made any 

change, the data-base remains definite and cannot 

be changed unless a factory default procedure is 

carried out (see procedure “B+3”).

7] GETTING STARTED