2
cdvigroup.com
Wiegand 26, 30 or 44 bit.
Direct connection or with the door controller
(INTBUSW).
PCB sealed in epoxy.
Audible and visual feedback.
30cm pigtail wire connection.
Versions available: white or black.
Dimensions (L x W x D): 130 x 90 x 28mm.
Technology: 13.56Mhz.
Input voltage: 12V dc.
Consumption: 220mA.
1] PRODUCT PRESENTATION
3] MOUNTING KIT
2] REMINDERS AND RECOMMENDATIONS
130
90
35
Foam seal
3x30
TF screw
S5 Plastic
anchor
Torx
®
bit
3x8
Torx
®
screw
Varistor
SOLARMW(MB)
1
2
2
1
1
1
Important
To protect the device from
back-emf, do not forget to
install the varistor across the
lock terminals, in parallel.
Suggested power supplies
ARD12 & BS60 (in case the
reader is powered neither
by the controller nor by the
reader controller INTBUSW).
These products must be
powered in 12Vdc and the
power supply should be
certified EN60950-1:2006/
A11:2009 standards and
should be designed to be a
low power supply source.
Recommended cables
4 twisted pairs 0.6mm (AWG 24).
This product is supplied
with a varistor.
The varistor must be
connected directly to the
locking system terminals
(electric strikes, electro-
magnet, or lock) operated
by the device. If the device
functions with several locking
systems, each one must
be fitted with a varistor.
The varistor limits overload
produced by the strike coil,
known as self-effect or
back-emf. If you are using
a “Shear Lock”, electromagnet
or other type of electric lock,
we recommend the use of
a dedicated power supply
for the lock.
For optimal
illumination,
do not fold
the cable
inside
the product.
CE Certification
Certification FCC CFR 47
part 15 compliance
WEEE
IP53
-25°C to +70°C
EN
SOLARMW-SOLARMB
13.56Mhz Mifare
®
Reader - Wiegand
INSTALLATION MANUAL
