21
ENCODER K
NOB
- V
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- V
.
GAS K
EY
Activates the flow of gas.
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP
Fx)
on the HT4 panel and not on the DH panel.
5 - WELDING
MIG dual pulse
When welding takes place the fields in the displays show the same values as those included for pre-setting
with the difference
that now, if possible, they are those measured
.
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
PROGRAM 2011
A
V
217 29.4
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
and subsequent menus, as
applicable.
SX K
EY
Scrolls in succession
THICKNESS OF WELDED ITEM
(
) -
WELDING CURRENT
( )
-
WIRE SPEED
(
) only on the
VISION S
CREEN
(this operation is activated when the key is
released).
In this case, where possible, the values displayed will be those measured.
ENCODER K
NOB
- SX
Adjusts the parameter selected using the
SX K
EY
.
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
DX K
EY
Scrolls in succession
ARC LENGTH ADJUSTMENT
( ) -
WELDING VOLTAGE
( ) -
ELECTRONIC INDUCTANCE
(
) only on the
VISION S
CREEN
(this operation is activated when
the key is released).
In this case, where possible, the values displayed will be those measured.
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
.
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
