24
WELDING MODE SELECTION K
EY
Scrolls the various welding modes in succession, interrupting the
HOLD Function
.
WELDING MODE SELECTION LED
The LED unit indicates the welding mode selected according to the
VISION S
CREEN
.
HOLD F
UNCTION
LED
Flashes for a set time, informing the operator that the
HOLD Function
is active.
PARAMETER DISPLAY S
CREEN
- V
Shows the parameter indicated by the
PARAMETER SELECTION LED - V
.
PARAMETER SELECTION LED - V
The LED unit indicates the welding parameter selected using the
PARAMETER SELECTION K
EY
- V
.
PARAMETER SELECTION K
EY
- V
Scrolls in succession
ARC LENGTH ADJUSTMENT
( ) -
WELDING VOLTAGE
( ) -
ELECTRONIC INDUCTANCE
(
) only on panel HT4.
In this case the values displayed are those for:
HOLD
.
ENCODER K
NOB
- V
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- V
interrupting the
HOLD
Function
.
GAS K
EY
Activates the flow of gas without interrupting the
HOLD Function
.
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering, interrupting the
HOLD Function
and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP Fx)
on the HT4 panel and not on the DH panel.
MIG-MAG synergic
1 - PROGRAM SELECTION Menu (PROGRAM)
MIG-MAG synergic
“DH” CONTROL PANEL
To access the
PROGRAM SELECTION Menu (PROGRAM)
push the
MENU K
EY
.
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
PRG MATERIAL Ø GAS
0012 Fe G3 SI-1
1.0 Ar 16-20% CO2
0013 Fe G3 SI-1
1.2 Ar 16-20% CO2
0014 Fe G3 SI-1
1.6 Ar 16-20% CO2
0031 Fe G3 SI-1
0.8
Ar 8-10% CO2
0032 Fe G3 SI-1
1.0
Ar 8-10% CO2
0014 Fe G3 SI-1 Ø 1.6 Ar 16-20% CO2
8/38
MENU K
EY
Used to access subsequent menus if there are any.
ENCODER K
NOB
- SX
Select the welding program.
ENTER/MEM K
EY
Used to access
PRE-SETTING
of the program selected.
“HT4” CONTROL PANEL
It is not possible to access the
PROGRAM SELECTION Menu (PROGRAM)
via the HT4 control panel.