37
ENCODER K
NOB
- SX
Adjusts the
WIRE SPEED
(
) parameter (the
WELDING CURRENT
( ) cannot be
adjusted).
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
DX K
EY
Scrolls in succession
WELDING VOLTAGE
( ) -
ELECTRONIC INDUCTANCE
(
) only on
the
VISION S
CREEN
.
In this case, where possible, the values displayed will be those measured.
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
.
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Shows the value (measured, if possible) for the parameter indicated by the
PARAMETER
SELECTION LED - A
.
PARAMETER SELECTION LED - A
The LED unit shows the welding parameter selected using the
PARAMETER SELECTION K
EY
- A
.
PARAMETER SELECTION K
EY
- A
Scrolls in succession
WELDING CURRENT
( ) -
WIRE SPEED
(
) only on the HT4 panel.
In this case, where possible, the values displayed will be those measured.
When welding is in progress the
WELDING CURRENT
( ) is displayed continuously until
this key is pushed.
ENCODER K
NOB
- A
Adjusts the
WIRE SPEED
(
) parameter (the
WELDING CURRENT
( ) cannot be
adjusted).
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
WELDING MODE SELECTION LED
The LED unit indicates the welding mode selected according to the
VISION S
CREEN
.
PARAMETER DISPLAY S
CREEN
- V
Shows the value (measured, if possible) for the parameter indicated by the
PARAMETER
SELECTION LED - V
.
PARAMETER SELECTION LED - V
The LED unit indicates the welding parameter selected using the
PARAMETER SELECTION K
EY
- V
.
PARAMETER SELECTION K
EY
- V
Scrolls in succession
WELDING VOLTAGE
( ) -
ELECTRONIC INDUCTANCE
(
).
In this case, where possible, the values displayed will be those measured.
ENCODER K
NOB
- V
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- V
.
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP
Fx)
on the HT4 panel and not on the DH panel.
