38
5 - HOLD
MIG-MAG manual
When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as
HOLD
. In this phase the
VISION S
CREEN
shows the
HOLD
box highlighted, while on the HT4
panel the
H
OLD
F
UNCTION
LED
flashes until the end of the
HOLD Function
. If the
HOLD Function
is Interrupted via a panel (e.g. DH),
it will also be interrupted automatically on the other (HT4) and vice-versa.
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
m/min
V
7.8 12.1
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
interrupting the
HOLD
Function
and subsequent menus, as applicable.
SX K
EY
Scrolls in succession
WELDING CURRENT
( ) -
WIRE SPEED
(
) only on the
VISION
S
CREEN
.
In this case the values displayed are those for:
HOLD
.
ENCODER K
NOB
- SX
Adjusts the parameter selected using the
SX K
EY
interrupting the
HOLD Function
.
ENTER/MEM K
EY
If held down for
3
consecutive seconds, it interrupts the
HOLD Function
and makes it
possible to access
SAVE JOB
.
DX K
EY
Scrolls in succession
WELDING VOLTAGE
( ) -
ELECTRONIC INDUCTANCE
(
) only on
the
VISION S
CREEN
.
In this case the values displayed are those for:
HOLD
.
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
interrupting the
HOLD Function
.
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Shows the parameter indicated by the
PARAMETER SELECTION LED - A
.
PARAMETER SELECTION LED - A
The LED unit shows the welding parameter selected using the
PARAMETER SELECTION K
EY
- A
.
PARAMETER SELECTION K
EY
- A
Scrolls in succession
WELDING CURRENT
( ) -
WIRE SPEED
(
) only on the HT4 panel.
In this case the values displayed are those for:
HOLD
.
ENCODER K
NOB
- A
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- A
interrupting the
HOLD
Function
.
WIRE K
EY
Activates loading of the wire without interrupting the
HOLD Function
.
WELDING MODE SELECTION K
EY
Scrolls the various welding modes in succession, interrupting the
HOLD Function
.
WELDING MODE SELECTION LED
The LED unit indicates the welding mode selected according to the
VISION S
CREEN
.
(continued)
