41
The
SPECIAL FUNCTIONS (Fx)
related to the
MMA
process correspond as follows to those on the wire feeder:
Special function
PARAMETER DISPLAY Screen - A
PARAMETER DISPLAY Screen - V
Default
Range
HOT START
Hot
50
(0 - 100)
ARC FORCE
ArC
50
(0 - 100)
WARNING:
• It is possible to access editing of the
SPECIAL FUNCTIONS (Fx)
during welding.
• Some of the values edited will be used immediately by the operator, while others will be active from when the next welding
task begins.
• The
HOLD
function is not active within the
SPECIAL FUNCTIONS Menu (SET UP Fx)
.
3 - PRE-SETTING
MMA
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
VRD
ACTIVE
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
A
V
60 70.0
MMA Cr Ni
PROGRAM 3200
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
and subsequent menus, as
applicable.
ENCODER K
NOB
- SX
Adjust the value of the parameter
WELDING CURRENT
( ).
DX K
EY
Scrolls in succession
WELDING VOLTAGE
( ) -
HOT START
( ) -
ARC FORCE
( ) only
on the
VISION S
CREEN
(the operation is activated when the key is released).
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
(only
HOT START
( ) -
ARC FORCE
( )).
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Displays the value of the parameter
WELDING CURRENT
( ).
PARAMETER SELECTION LED - A
The LED unit shows the
WELDING CURRENT
( ) switched on.
ENCODER K
NOB
- A
Adjust the value of the parameter
WELDING CURRENT
( ).
(continued)