42
PARAMETER DISPLAY S
CREEN
- V
Shows the parameter indicated by the
PARAMETER SELECTION LED - V
.
The
WELDING VOLTAGE
shown is the measured voltage.
PARAMETER SELECTION LED - V
The LED unit indicates the welding parameter selected using the
PARAMETER SELECTION K
EY
- V
.
PARAMETER SELECTION K
EY
- V
Scrolls in succession the parameters
HOT START
( ) -
WELDING VOLTAGE
( ) -
ARC
FORCE
(
).
ENCODER K
NOB
- V
Adjusts the parameter displayed by the
PARAMETER DISPLAY S
CREEN
- V
.
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP
Fx)
on the HT4 panel and not on the DH panel.
4 - WELDING
MMA
When welding takes place the fields in the displays show the same values as those included for pre-setting
with the difference
that now, if possible, they are those measured
.
“DH” CONTROL PANEL
VRD
IN
OPERATION
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
A
V
60 70.0
MMA Cr Ni
PROGRAM 3200
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
and subsequent menus, as
applicable.
ENCODER K
NOB
- SX
Adjust the value of the parameter
WELDING CURRENT
( ).
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
DX K
EY
Scrolls in succession
WELDING VOLTAGE
( ) -
HOT START
( ) -
ARC FORCE
( ) only
on the
VISION S
CREEN
(the operation is activated when the key is released).
In this case, where possible, the values displayed will be those measured.
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
(only
HOT START
( ) -
ARC FORCE
( )).
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Displays the value of the parameter
WELDING CURRENT
( ).
PARAMETER SELECTION LED - A
The LED unit shows the
WELDING CURRENT
( ) switched on.
(continued)
