43
ENCODER K
NOB
- A
Adjust the value of the parameter
WELDING CURRENT
( ).
In this case the values displayed become those pre-set.
After a period of
3
seconds the values displayed go back to those measured if possible.
PARAMETER DISPLAY S
CREEN
- V
Shows the value (measured, if possible) for the parameter indicated by the
PARAMETER
SELECTION LED - V
.
PARAMETER SELECTION LED - V
The LED unit indicates the welding parameter selected using the
PARAMETER SELECTION K
EY
- V
.
PARAMETER SELECTION K
EY
- V
Scrolls in succession the parameters
HOT START
( ) -
WELDING VOLTAGE
( ) -
ARC
FORCE
(
) only on the HT4 panel.
ENCODER K
NOB
- V
Scrolls in succession the parameters
HOT START
( ) -
ARC FORCE
(
).
SPECIAL FUNCTIONS (F
X
) K
EY
Only enables entering and exit afterwards from the
SPECIAL FUNCTIONS Menu (SET UP
Fx)
on the HT4 panel and not on the DH panel.
5 - HOLD
MMA
When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as
HOLD
. In this phase the
VISION S
CREEN
shows the
HOLD
box highlighted, while on the HT4
panel the
HOLD F
UNCTION
LED
flashes until the end of the
HOLD Function
. If the
HOLD Function
is Interrupted via a panel (e.g. DH),
it will also be interrupted automatically on the other (HT4) and vice-versa.
“DH” CONTROL PANEL
A
V
68
7.2
MMA Cr Ni
PROGRAM 3200
VRD
ACTIVE
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
interrupting the
HOLD
Function
and subsequent menus, as applicable.
ENCODER K
NOB
- SX
Adjusts the
WELDING CURRENT
( ) parameter, interrupting the
HOLD Function
.
ENTER/MEM K
EY
If held down for
3
consecutive seconds, it interrupts the
HOLD Function
and makes it
possible to access
SAVE JOB
.
DX K
EY
Scrolls in succession
WELDING VOLTAGE
( ) -
HOT START
( ) -
ARC FORCE
( ) only
on the
VISION S
CREEN
(the operation is activated when the key is released).
In this case the values displayed are those for
HOLD
(only for the welding voltage).
ENCODER K
NOB
- DX
Adjusts the parameter selected using the
DX K
EY
interrupting the
HOLD Function
.