46
The
SPECIAL FUNCTIONS (Fx)
related to the
TIG LIFT
process correspond as follows to those on the wire feeder:
Special function
PARAMETER DISPLAY Screen - A
PARAMETER DISPLAY Screen - V
Default
Range
UP SLOPE
F29
0.0s
(0.0 - 5.0)s
DOWN SLOPE
F30
2.0s
(0.0 - 8.0)s
SWS VOLTAGE THRESHOLD
F31
0
-30 - +30
WARNING:
• It is possible to access editing of the
SPECIAL FUNCTIONS (Fx)
during welding.
• Some of the values edited will be used immediately by the operator, while others will be active from when the next welding
task begins.
• The
HOLD
function is not active within the
SPECIAL FUNCTIONS Menu (SET UP Fx)
.
2 - PRE-SETTING
TIG LIFT
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
A
V
111 50.0
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
and subsequent menus, as
applicable.
ENCODER K
NOB
- SX
Adjust the value of the parameter
WELDING CURRENT
( ).
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Displays the value of the parameter
WELDING CURRENT
( ).
PARAMETER SELECTION LED - A
The LED unit shows the
WELDING CURRENT
( ) switched on.
ENCODER K
NOB
- A
Adjust the value of the parameter
WELDING CURRENT
( ).
PARAMETER DISPLAY S
CREEN
- V
Displays the value of the parameter
WELDING VOLTAGE
( ).
The
WELDING VOLTAGE
shown is the measured voltage.
(continued)
