53
5 - HOLD
JOB
When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as
HOLD
. In this phase the
VISION S
CREEN
shows the
HOLD
box highlighted, while on the HT4
panel the
HOLD F
UNCTION
LED
flashes until the end of the
HOLD Function
. If the
HOLD Function
is Interrupted via a panel (e.g. DH),
it will also be interrupted automatically on the other (HT4) and vice-versa.
WARNING:
All the parameters saved within a JOB (including SPECIAL FUNCTIONS (Fx)) can be viewed but not edited!
“DH” CONTROL PANEL
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
m/min
V
11.1 33.3
013
MENU K
EY
Used to access the
PROCESS SELECTION Menu (PROCESS)
interrupting the
HOLD
Function
and subsequent menus, as applicable.
SX K
EY
Scrolls the active parameters in succession, only on the
VISION S
CREEN
, based on the type of
welding process saved in the
JOB
selected.
ENTER/MEM K
EY
If held down for
3
consecutive seconds, it interrupts the
HOLD Function
and makes it
possible to access
SAVE JOB
.
DX K
EY
Scrolls the active parameters in succession, only on the
VISION S
CREEN
, based on the type of
welding process saved in the
JOB
selected.
In this case the values displayed are those for:
HOLD
.
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Shows the JOB term or value of the parameter indicated by the
PARAMETER SELECTION LED -
A
.
PARAMETER SELECTION LED - A
The LED unit shows the welding parameter selected using the
PARAMETER SELECTION K
EY
- A
.
PARAMETER SELECTION K
EY
- A
Scrolls the active parameters in succession, based on the type of welding process saved in
the
JOB
selected.
In this case the values displayed are those for:
HOLD
.
WIRE K
EY
Activates loading of the wire without interrupting the
HOLD Function
.
(continued)