55
“HT4” CONTROL PANEL
WELDING MODE SELECTION LED
WELDING MODE SELECTION K
EY
WIRE K
EY
ENCODER K
NOB
- A
PARAMETER SELECTION K
EY
- A
PARAMETER SELECTION LED - A
PARAMETER DISPLAY S
CREEN
- A
SPECIAL FUNCTIONS (F
X
) LED
SPECIAL FUNCTIONS (F
X
) K
EY
GAS K
EY
ENCODER K
NOB
- V
PARAMETER SELECTION K
EY
- V
PARAMETER SELECTION LED - V
PARAMETER DISPLAY S
CREEN
- V
HOLD Function LED
PARAMETER DISPLAY S
CREEN
- A
Displays the error message (e.g. Err.).
PARAMETER DISPLAY S
CREEN
- V
Shows the alarm code (e.g. E1.0) of in succession, the codes for the alarms in succession if
there are a number of errors.
In the case of an
Automatically reset error
once the alarm condition has ended (reinstatement completed correctly), the weld-
ing plant is once again ready and the operator can recommence welding! The alarm state disappears and the
VISION S
CREEN
re-
turns to precisely the same point at which it was operating previously.
PLEASE NOTE:
After resetting has been completed, during normal operation of the machine, the
VISION S
CREEN
will still show the
error signal to inform the operator of the event ( ), but this can be removed visually from the display by simply pushing the
MENU
K
EY
.
WARNING:
This only removes the visual error indication but not the history of what happened!
In the case of
NON automatically reset errors
, to remove the alarm status and reinstate correct operation of the machine, the
welding plant must be switched off.
When it is switched on again, the machine will be working again and the operator can weld again!
PLEASE NOTE:
If, when switching on, the error status presents itself again, immediately contact Technical Assistance
Department.
SETUP Menu
“DH” CONTROL PANEL
To access the
SETUP Menu
hold down for at least
5
consecutive seconds the
SX K
EY
.
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
SETUP
MENU K
EY
Used to exit the
SETUP Menu
and take the
VISION S
CREEN
back to the entry phase.
ENCODER K
NOB
- SX
Used to scroll the various icons (sub-menus) in the menu and then select them.
ENTER/MEM K
EY
Used to access the menu related to the icon selected.
WARNING:
• It is impossible to weld!
• If the
VISION S
CREEN
is protected by a password, access to this menu will only be allowed by entering the correct password.