63
ERROR LOG
SETUP Menu
The purpose of this menu is to allow the operator to know, interpret, and understand error conditions that have occurred or may
be encountered on the welding plant.
To access the
ERROR LOG Menu
from the
SETUP Menu
:
• Turn the
ENCODER K
NOB
- SX
to select the desired icon.
• Push the
ENTER/MEM K
EY
.
MENU K
EY
ENTER/MEM K
EY
ENCODER K
NOB
- SX
ENCODER K
NOB
- DX
VISION S
CREEN
SX K
EY
DX K
EY
ERRORS Curr.
Tot.
E0.5 REMOTE COMMANDS
0
0
E0.6 WATER COOLER MISSING
1
5
E0.7 MOTOR SPEED
0
0
E0.8 WIRE FEEDER MISSING
0
0
T°C THERMAL PROTECTION
0
0
E7.0 RC ANALOGIC MISSING
1
2
Within the menu the following is indicated for each individual error:
• Its code (e.g. E1.0).
• A short description (e.g. no configuration file).
• The number of times this has occurred since the last time the machine was switched on (Curr).
• The number of times this has occurred since the last ALARM COUNTER RESET or TOTAL RESET (Tot.) of the welding machine.
• Errors that have occurred on the welding plant and subsequently been corrected, but not yet partially reset, are highlighted in
yellow.
• Errors that have occurred on the welding machine, but that have not yet been resolved and so are still active, are highlighted
in red.
RESET Curr (RESET PARTIAL ERROR COUNT)
ERRORS Curr.
Tot.
E0.1 OVER AND UNDER VOLTAGE
0
0
E0.2 OVER VOLTAGE
0
0
E0.3 UNDER VOLTAGE
0
0
E0.4 OVER CURRENT
0
0
E0.5 REMOTE COMMANDS
0
0
E0.6 WATER COOLER MISSING
1
6
The counter that indicates how many times a error or alarm has occurred since the last time the
machine was switched on is part of this menu, and can be zeroed as follows:
• Choose the error for which the partial counter (Curr) must be reset by rotating the
SX - ENCODER K
NOB
.
• The
VISION S
CREEN
displays an icon in the bottom right corner (see image) that indicates that you can
proceed with resetting.
• Hold down the
DX K
EY
until resetting of the (Curr) counter has been completed.
Within the menu, by rotating the
ENCODER K
NOB
- SX
it is possible to scroll the errors (also indicated in the table below), view them
and select them.
Error
condition
Error code
Error description and possible diagnosis
Err
E0.0
POWER SUPPLY FAILURE
NON automatic reset error.
This error can only arise when switching on and not when the welding plant is working normally.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E0.1
OVER AND UNDER VOLTAGE
Automatic reset error.
Err
E0.2
OVER VOLTAGE
Automatic reset error.
Err
E0.3
UNDER VOLTAGE
Automatic reset error.
Err
E0.4
OVER CURRENT
Automatic reset error.
Err
E0.5
REMOTE COMMANDS
No feed for remote commands.
NON automatic reset error.
(continued)